| View previous topic :: View next topic |
| Author |
Message |
rneal
Joined: 13 Jul 2003
Posts: 10
Location: Washington State
|
 Posted: Sun Aug 17, 2003 13:57 Post subject: Bulletin board |
 |
|
How do I put the little picture to the left of the message I send?
Bob Neal
_________________
Mr. Neal published books on both Packard and Liberty engines. He died on 20 February 2015. |
|
| Back to top |
|
 |
kmccutcheon
Joined: 13 Jul 2003
Posts: 298
Location: Huntsville, Alabama USA
|
| Posted: Sun Aug 17, 2003 14:24 Post subject: |
|
|
Here is how to put a picture (avatar) to the left of your message:
1. Prepare a .jpg or .gif image that is no more than 80 pixels in any dimension.
2. Click on your “Profile”.
3. Scroll down to the “Avatar Control Panel”.
4. Use the “Browse” feature of the “Upload Avatar from your machine” option to find the image that you prepared in step 1 and “open” it.
5. Click “Submit”.
The image you selected will be displayed from that point forward.
_________________
Kimble D. McCutcheon |
|
| Back to top |
|
|
thaggard
Joined: 13 Jul 2003
Posts: 2
Location: Lima Ohio
|
| Posted: Sun Aug 17, 2003 17:40 Post subject: |
|
|
| How can I put my address down? My phone#? My e-mail is haggard@ohiolink.net |
|
| Back to top |
|
|
kmccutcheon
Joined: 13 Jul 2003
Posts: 298
Location: Huntsville, Alabama USA
|
| Posted: Sun Aug 17, 2003 18:17 Post subject: |
|
|
This is also done by modifying your profile. I would advise caution, though, especially with your email and telephone. Your profile is available to anyone anywhere on the internet. Putting your email and telephone number on your profile will practically guarantee spam and unsolicited telephone calls.
_________________
Kimble D. McCutcheon |
|
| Back to top |
|
|
rlawrence
Joined: 13 Jul 2003
Posts: 4
|
| Posted: Sat Jul 04, 2009 05:35 Post subject: Martin B-26 props |
|
|
| SOP was: On run up pilot turned around & made sure generators were putting out by checking the volt meters on the bulkhead at the rear of the crew compartment. If you didn`t & the batteries were up so the props cycled OK on runup, there was enought juice to control them about to rotation when you`d run out of electricity & they`d run away & witha load you were all done. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Profile
Log in to check your private messages
Log in
